Sw In/Out - Switching Input/Switching Output - Leuze electronic BPS 34 Technical Description

Specifications BPS 34
4.3.4

SW IN/OUT - switching input/switching output

SW IN/OUT
SWOUT
VOUT
1
M 12 socket
(A-coded)
Figure 4.7:
Attention!
Protection class IP 65 is achieved only if the connectors and caps are screwed into place!
Notice!
Programming of the switching input/switching output is performed via module 7 (Switching
input) and module 8 (Switching output). For further information, see also chapter 8.1.7.7,
page 59 ff.
Notice!
The switching input/switching output of the PWR IN plug connection is identical to the SWIN
switching input and SWOUT switching output of the SW IN/OUT plug connection on the
MS 34 105.
Attention!
If you use a sensor with a standard M 12 connector, then please note the following:
Only use sensors on which the switching output does not lie on pin 2, i.e. only sensor cables
on which pin 2 is not assigned. Otherwise, the switching output is not protected against feed-
back on the switching input. If the inverted sensor output lies on pin 2, erroneous behaviour
of the switching output will result!
20
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
SW IN/OUT (5-pin socket, A-coded)
Pin
1
2
GND
3
2
4
PE
3
SWIN
4
5
Thread
Pin assignment SW IN/OUT
Name
Supply voltage for sensors
(VOUT identical to VIN at PWR IN)
VOUT
without optics heating: +10 ... +30 V DC
with optics heating: +22 ... +26 V DC
SWOUT Switching output
GND Supply voltage for sensors 0 V DC
SWIN Switching input
PE Functional earth
PE Functional earth (housing)
BPS 34
Leuze electronic
Remark
Leuze electronic