Installation Environment - Tadiran Telecom Coral FlexiCom 6000 Installation Procedure And Hardware Reference Manual

2
Coral FlexiCom 6000 Installation Manual

Installation Environment

...................................................................................................
Follow this detailed procedure to ensure a proper Installation Environment:
1. Verify that the installation area is clean, dry, and protected from weather
extremes.
2. Verify that the floor of the installation area is finished with linoleum, vinyl,
ceramic, wooden flooring, or polished sealed concrete.
Carpeting is not acceptable.
3. Verify that the ceiling of the installation area is finished or treated to prevent
particle discharge and water damage.
4. Verify that the installation area is well lit, and that the light source is uniformly
diffused without shadows. Adequate lighting should provide a comfortable
reading level and allow the identification of wire insulator colors without
undue eye fatigue.
Lighting should be comparable to an office work environment, with a
minimum level of 70 foot-candles at each work surface. As a general rule, in a
room with an eight foot (2.5m) ceiling, one 48 inch fluorescent tube provides
sufficient illumination for 20-25 sq. ft. (1.9-2.4m
5. Verify that ventilation of the installation area is capable of maintaining an
ambient temperature of 32-104° F (0-40° C), and a relative humidity of
20-80% non-condensing, while the system is operating as listed in
These figures are for each cabinet only, and do not take into account heat
generated by other equipment. In particular, charging fully-discharged batteries
may generate a considerable amount of heat, depending on battery capacity
and rate of charge. Refer to the equipment manufacturer data for more
information.
6. Verify that the installation area is free of caustic or corrosive liquids,
substances, or materials. If batteries are installed as part of the system, ensure
that adequate precautions are taken (such as special ventilation) to prevent
corrosive emissions from the batteries. Check local building codes for
additional requirements.
2
).
Table
Hardware Installation Procedure
2-2.
2-3