Table of Contents
Advertisement
31 December 1992
18. 220/230/240 V version
machines only.
If the voltage of electrical
power supply from the wall
outlets is 230 V or 240 V,
change the voltage as
follows:
a) Open the lower
registration guide plate [A]
(4 screws [B]) as shown.
b) Connect the input line
[C] to the appropriate
voltage (230 V or 240 V).
c) Reinstall the lower
registration guide plate.
19. Turn on DIP SW 101-7
and 8 on the main board
[C]. Then plug in the
power cord and turn on
the main switch [D].
20. Evenly pour 3 kg of
developer into the
development unit as
shown.
Close the cartridge
cover and the original
feed unit.
INSTALLATION PROCEDURE
[A]
[B]
[D]
3-11
[C]
[C]
Advertisement
Table of Contents
