Table of Contents
Advertisement
OTHERS
11.2 ORIGINAL ENTRANCE SENSOR AND SWITCH BACK
GATE SENSOR
[A]
[B]
1. Open the original feed unit.
2. Remove the top right cover.
3. Set the rear original table [A] to the down position.
4. Remove the original feed rear cover [B] (3 screws).
5. Remove the original entrance sensor bracket [C] (2 screws and 1
connector).
6. Remove the original entrance sensor [D] from the bracket (1 screw).
7. Remove the switch back gate sensor bracket [E] (1 screw and 1
connector).
8. Remove the switch back gate sensor [F] from the bracket (1 screw).
[C]
5-68
31 December 1992
[D]
[E]
[F]
Advertisement
Table of Contents
