Dip Switches - Ricoh FW830 Service Manual

31 December 1992

2.3 DIP SWITCHES

Main Board
NUMBER
DPS101-1
DPS101-2
DPS101-3
DPS101-4
DPS101-5
DPS101-6
DPS101-7
DPS101-8
DPS102-1
to
DPS102-6
DPS102-7
DPS102-8
SW101
* Increments the total counter every meter of paper.
** Increments the total counter 100 inches of paper.
*** Refer to the Service Tools section for details.
Note: 1. DPS101-4 is effective only when the DPS101-3 is turned off
(length counter).
2. Do not change DPS101-3 and 101-4 positions from the
factory setting.
3. If a main CPU malfunction occurs, turn on SW101 to
reset the main CPU.
4. In the free run mode (DPS101-1 ON), the copier automatically
operates without paper feeding after the original is inserted
and pulled out.
5. To clear the service call condition for fusing (E2, E3, E4, E5,
E6, E9 and EA), the position of DPS102-8 must be changed
from OFF to ON or from ON to OFF before the main switch
is turned on.
OFF
Normal
Normal
Length counter
(for total counter)
*Millimeters
Normal
Normal
Normal
Normal
Not used
50 Hz (paper feed
motor of the roll feeder)
Service call reset
Normal
Free run (A1 sideways/D size feed cycle)
Forced ready condition (no warm-up)
Copy counter (for total counter)
**Inches
***Clear counter memory
***Input check
***Output check
***Service program mode (SP mode)
60 Hz (paper feed motor of the roll feeder)
Service call reset
Sends the reset signal to the main CPU
4-13
SERVICE TABLES
ON