Table of Contents
Advertisement
FUSING AND PAPER EXIT
31 December 1992
The hot roller strippers [F] separate the copy from the hot roller and direct it
to the fusing exit rollers [G]. After the fusing exit rollers, the exit gate [H]
directs the copy to either the upper rollers [I] or lower exit [J].
When the exit gate solenoid is on, the exit gate directs the copy paper down
through the lower copy exit path. If the exit gate solenoid is off, the paper
goes through the upper copy exit path. The exit direction is selected using
the Copy Exit Way key.
Two thermofuses (wired parallel) [K] provide backup overheat protection.
(See the section on fusing temperature control.)
The fusing exit, upper exit, and lower exit sensors [L, M, N] are used for jam
detector.
2-40
Advertisement
Table of Contents
