Table of Contents
Advertisement
31 December 1992
3. Enter the desired SP mode number as follows:
a) Press the Margin key [C]. "00" will blink in the Leading Margin indicator
[D]. Enter the desired SP mode number using the Plus [E] or Minus [F]
key (The SP mode numbers are given in the Service Program Mode
Table).
b) Press the Margin Set key [G]. "00" will blink in the Trailing Margin
indicator [H]. Enter the desired SP mode number using the Plus or
Minus key (The SP mode numbers are given in the Service Program
Mode Table.)
Press the Margin Set key again. Then, the data will be displayed in the
Copy Counter indicator [I].
4. Enter the desired value or mode using the Plus or Minus key, and then
press the Copy Exit Way key [J] (SP mode data are given in the Service
Program Mode Table).
NOTE: 1. The beeper will sound three times after a value or mode is
entered.
2. For some SP modes, you only need to press the Copy Exit
Way key directly without pressing the Plus or Minus key.
(These SP modes are marked "#" in the Service Program
Mode Table.)
5. Input a new SP mode number as follows: (when changing to another
mode number)
a) Press the Margin key. A number will blink in the Leading Margin
indicator. Enter the desired SP mode number using the Plus or Minus
key.
NOTE: It is possible to input a new SP mode number when the
number in the Leading Margin indicator is blinking.
b) Press the Margin Set key. A number will blink in the Trailing Margin
indicator. Enter the desired SP mode number using the Plus key or
Minus key. Press the Margin Set key again.
NOTE: It is possible to input a new SP mode number when the
number in the Trailing Margin indicator is blinking.
6. To leave the SP mode, turn off the DSP101-8.
4-15
SERVICE TOOLS
Advertisement
Table of Contents
