FUSING
9.6
FUSING PRESSURE DISTRIBUTION ADJUSTMENT
1. Remove the fusing unit. (See Fusing Unit Removal.)
2. Remove the hot roller and the pressure roller [A]. (See Hot
Roller/Pressure Roller Replacement.)
3. Slide the pressure roller shaft [B] out from the pressure roller.
4. Loosen the four Allen screws on each of the adjustment bearings [C,D].
5. Set the bearings in the desired positions and tighten the Allen screws.
[C]
[D]
5-56
[A]
[B]
31 December 1992