Table of Contents
Advertisement
31 December 1992
9.3
HOT ROLLER/PRESSURE ROLLER REPLACEMENT
[J]
[I]
[F]
[G]
[C]
[K]
1. Remove the fusing unit. (See Fusing Unit Removal.)
2. Remove the fusing lamp. (See Fusing Lamp Replacement.)
3. Remove the fusing upper cover [A] (4 screws) and the exit guide plate [B]
(4 screws).
4. Remove the left and right pressure springs [C,D].
5. Remove the entrance guide plate [E] (2 screws).
6. Remove the right stopper [F] (1 screw).
7. Remove two C rings [G], the gear [H], two bushings [I], and two bearings
[J].
8. Slide the hot roller [K] to the right and pull it out.
9. Remove two stoppers [L] (1 screw each), then, remove the pressure roller
[M].
[J]
[H]
[D]
[L]
5-53
[B]
[I]
[G]
[M]
FUSING
[A]
[E]
[L]
Advertisement
Table of Contents
