Ricoh FW830 Service Manual page 130

Hide thumbs Also See for FW830:
Table of Contents

Advertisement

31 December 1992
Code
(DJ =)
22
Original is too small. (Minimum: B5 lengthwise)
23
Original is pulled out from the rear original table
after the original registration sensor turns on but
before the original registration rollers start turning.
24
Original is under the original set sensor when the
original stopper solenoid turns on. (When the
original is fed from the front original table.)
25
Original is under the original entrance sensor
when the original stopper solenoid turns on.
(When the original is fed from the rear original
table.)
26
Original is pulled out from the front original table
after the registration sensor turns on but before
the original registration rollers start turning.
27
The 1st original transport sensor stays on when
the 2nd original transport sensor trailing edge
OFF check. (When the original is fed from the
front original table.)
28
The original registration sensor stays on when
the original exit sensor trailing edge OFF check.
(When the original is fed from the rear original
table.)
29
Original registration sensor ON check for the
switch back mode.
30
Original entrance sensor ON check for the switch
back mode.
31
Switch back gate does not move to the up
position when the switch back gate solenoid turns
on.
32
2nd original transport sensor trailing edge OFF
check.
33
1st original transport sensor leading/trailing edge
OFF check for repeat copy.
34
1st original transport sensor ON check for repeat
copy.
35
Original registration sensor trailing edge OFF
check.
36
Original exit sensor ON check.
37
Original exit sensor leading/trailing edge OFF
check.
38
Original is too long. (Maximum: 3.6 meters)
39
Recycle gate does not return to the original
position (up position) when the recycle gate
solenoid turns off.
Cause of Jam
4-45
JAM CODE LIST
SP Mode No
(Original Misfeed Counter)
SP43
(Upper transport section)
SP45
(Lower transport section)
SP47
(Recycle gate/switch back
gate)
SP43
(Upper transport section)
SP45
(Lower transport section)
SP44
(Turn section)
SP47
(Recycle gate/switch back
gate)

Advertisement

Table of Contents
loading

Table of Contents