DEVELOPMENT
[C]
8. Turn on the main switch.
9. Turn on the DPS101-7 and 101-8 on the main board to enter the output
check mode.
10. Enter output check No.1 to turn on the development motor. (See Output
Check Mode Access Procedure.)
The development rollers will start turning and the remaining developer [A]
inside the development unit will pour out onto the paper [B]. After about
15 minutes, nearly all of the developer will be out of the development unit.
NOTE: To remove all the developer, lift the left side [C] of the copier as
shown.
11. Press the Copy Exit Way key to turn off the development motor.
12. Pour the old developer into a plastic bag for disposal.
13. Reinstall the all covers except the middle right cover.
14. Install the new developer.
NOTE: After installing the new developer, perform the Initial
Conditioning (SP#5) and Toner Density Sensor Voltage
Adjustment (SP#35).
[B]
5-24
31 December 1992
[A]