Table of Contents
Advertisement
31 December 1992
3. Press the Plus or Minus key to display "9" on the Copy Counter indicator.
4. Press the Copy Exit Way key to clear memory.
5. Turn off DPS101-5 and 101-8.
6. Clean the optics, sensors, and inside of the copier if necessary.
7. Replace the old developer with new one.
CAUTION: Since the developer counter (SP64) for the developer
counter correction has been cleared, the old developer
cannot be used.
8. Perform the following SP modes in sequence.
(1) SP#13: Pheripheral Installation (If pheripherals are installed)
(2) SP#80 ~ SP#85, SP#90 ~ SP#95: Cut Error Corrections (If the roll
(3) SP#5: Initial Conditioning
(4) SP#35: Toner Density Sensor Adjustment
(5) SP#33: Vsg Adjustment
(6) SP#37: ADS Reference Voltage Adjustment
(7) Light Sensor Adjustment (by using VR102 on the main board)
(8) SP#26 or SP#27: Registration Adjustment—Manual Feed and Sheet
(9) SP#78 or SP#79: Registration Adjustment—Roll Feeder (If the roll
(10) SP#76 or SP#77: Cut Length Adjustment—Synchro Cut Mode
(11) SP#88 or SP#89: Cut Length Adjustment—Preset Cut Mode
feeder is installed)
Feeder
feeder is installed)
(If the roll feeder is installed)
(If the roll feeder is installed)
4-43
SERVICE TOOLS
Advertisement
Table of Contents
