DEVELOPMENT
[A]
[E]
[D]
[G]
9. Remove the front exposure glass holder [A] (4 screws).
NOTE: Do not loosen the two paint locked screws securing the holder.
10. Loosen the two screws [B] securing the doctor blade [C].
11. Insert the 0.35 mm DG gauge [D] in the center position of the doctor gap.
12. Insert the 0.5 mm DG gauge [E] in the rear position of the doctor gap.
13. While pressing down the doctor blade directly between the two gauges,
tighten the rear screw [F].
14. Remove the 0.5 mm DG gauge and reinsert it in the front position of the
doctor gap.
15. While pressing down the doctor blade directory between two gauges,
tighten the front screw [G].
16. Remove the two DG gauges and reassemble the machine.
[F]
5-32
31 December 1992
[B]
[C]