Ricoh FW830 Service Manual page 104

SERVICE TOOLS
Mode No.
No. Leading Trailing
Margin Margin
Indicator Indicator
9 00 09
°
10 01 00
°
11 01 01
°
12 01 02
°
13 01 03
15 01 05
16 01 06
17 01 07
18 01 08
Function
Key Tone ON/OFF
Selects key tone on or off.
Default ID Setting
Specifies whether the copier defaults to
ADS or manual ID level 7 when the main
switch is turned on.
Default Paper feed
Specifies whether the copier defaults to
sheet feeder, synchro cut, preset cut, or
manual feed when the main switch is
turned on.
Default Paper Exit
Specifies whether the copier defaults to
upper exit or lower exit.
Pheripherals Installation
Enables peripheral operation.
This SP mode must be done whenever
pheripheral is installed.
Copy Paper/Original Waiting Time
After the original (copy paper) is inserted,
the copier will wait for the set number of
minutes before feeding the original (copy
paper) out, if no copy paper (original) is
inserted.
Factory Use
Toner Supply Amount
Determines how much toner is supplied.
ID Sensor Bias Adjustment
Sets the bias voltage applied to the
development roller for the ID sensor pattern.
The ID sensor bias voltage is also
decreased or increased by the developer
counter correction.
The value for the developer counter
correction is decided according to the
Vsp/Vsg data obtained from initial
conditioning.(SP#5)
4-18
31 December 1992
Data
0: ON
1: OFF
0: ADS
1: Manual ID level 7
0: Sheet feeder
1: Synchro cut
2: Preset cut: 1189
3: Preset cut: 841
4: Preset cut: 594
5: Preset cut: 420
6: Preset cut: 297
7: Manual feed
0: Upper exit
1: Lower exit
0: Copier + Sheet
Feeder + Roll
Feeder
1: Copier + Roll
Feeder + Roll
Feeder Connector
2: Copier + Sheet
Feeder
3: Copier only
0: 2 minutes
1: 1 minute
2: 3 minutes
3: 4 minutes
4: 5 minutes
5: No limit
0: 15%
1: 7.5%
2: 30%
3: 60%
0: –200V
1: –180V
2: –240V
3: –280V
4: –320V