Table of Contents
Advertisement
31 December 1992
[A]
[H]
[G]
[F]
[E]
[D]
14. Remove the lamp regulator/CBG power pack assembly [A] (4 screws, 3
terminals, and 4 connectors).
15. Remove the front left cover [B] and remove the development motor [C] (5
screws).
16. Disconnect the bias terminal [D] (1 screw).
17. Remove the development drive gear [E], left positioning gear [F], left
positioning plate [G] and two bearings [H] (1 C-ring).
18. Remove the auger gear [I] (2 E-rings and 1 bushing).
[C]
[I]
5-37
DEVELOPMENT
[B]
Advertisement
Table of Contents
