Table of Contents
Advertisement
31 December 1992
3. Enter the desired input check number as follows:
a) Press the Margin key [C]. "00" will blink in the Leading Margin indicator
[D]. Enter the desired input check number using the Plus [E] or Minus
[F] key.
(The input check numbers are given in the Input Check Mode Table.)
b) Press the Margin Set key [G]. "00" will blink in the Trailing Margin
indicator [H].
Enter the desired input check number using the Plus or Minus key.
(The input check numbers are given in the Input Check Mode Table.)
Then, the current electrical component status will be displayed in the
Upper Exit indicator [I] or Lower Exit indicator [J].
4. Input a new input check number as follows: (When changing to another
mode number)
a) Press the Margin key. A number will blink in the Leading Margin
indicator. Enter the desired input check number using the Plus or
Minus key.
NOTE: It is possible to input a new input check number when the
number in the Leading Margin indicator is blinking.
b) Press the Margin Set key. A number will blink in the Trailing Margin
indicator. Enter the desired input number using the Plus or Minus key.
Press the Margin Set key again.
NOTE: It is possible to input a new input check number when the
number in the Trailing Margin indicator is blinking.
5. To leave input check mode, turn off DPS101-6 and 101-8.
4-33
SERVICE TOOLS
Advertisement
Table of Contents
