Table of Contents
Advertisement
DEVELOPMENT
[B]
[G]
7. Remove the front left cover [A], and remove the development motor [B] (5
screws).
8. Loosen the adjustment screws [C][D] at both ends of the development
roller [E].
9. Insert the 1.0 mm thickness gauge [F] between the drum and the
development roller. Set the gap to the adjustment standard while turning
the front [G] and rear [H] positioning gears clockwise or counterclockwise
and tighten the adjustment screws.
10. Reinstall the all units and covers.
NOTE: After reinstalling the doctor blade, adjust the doctor gap.
[C]
[E]
5-34
31 December 1992
[A]
[F]
[D]
[H]
Advertisement
Table of Contents
