Table of Contents
Advertisement
31 December 1992
[A]
–To Install–
1. Remove the left [A] and right [B] drum holders from the back side of the
main board bracket [C].
2. Disconnect the transfer [D] and separation [E] connectors.
3. Lift the T/S corona unit [F] and disconnect the ground wire connector [G].
4. Remove the T/S corona unit.
5. Place the left and right drum holders on the main frame as shown.
NOTE: "A" is written on the left drum holder and "B" is written on the
right drum holder.
[C]
[B]
[A]
5-9
[E]
[D]
[G]
[B]
DRUM
[F]
Advertisement
Table of Contents
