Table of Contents
Advertisement
SERVICE REMARKS
8) Perform the following SP modes in sequence.
(1) SP#13: Pheripherals Installation (If pheripherals are installed)
(2) SP#80 ~ SP#85, SP#90 ~ SP#95: Cut Error Corrections (If the roll
(3) SP#5: Initial Conditioning
(4) SP#35: Toner Density Sensor Adjustment
(5) SP#33: Vsg Adjustment
(6) SP#37: ADS Reference Voltage Adjustment
(7) Light Sensor Adjustment (by using VR102 on the main board)
(8) SP#26 or SP#27: Registration Adjustment Manual Feed and Sheet
(9) SP#78 or SP#79: Registration Adjustment—Roll Feeder
(10) SP#76 or SP#77: Cut Length Adjustment—Synchro Cut Mode
(11) SP#88 or SP#89: Cut Length Adjustment—Preset Cut Mode
3. When replacing a sensor, do not overtighten the screws. This may dam-
age the sensor.
Feeder
(If the roll feeder is installed)
(If the roll feeder is installed)
(If the roll feeder is installed)
4-54
feeder is installed)
31 December 1992
Advertisement
Table of Contents
