31 December 1992
[E]
[A]
10. Reinstall the cover plate [A] (1 ground screw).
NOTE: The right positioning pin [B] is inserted in the hole [C] while the
left positioning pins [D] are inserted in the holes [E].
11. Reinstall the pick-off pawl unit [F] (2 knob screws and 2 connectors).
NOTE: Make sure the two positioning pins [G] are inserted in the two
holes [H] of the pick-off pawl unit.
12. Pull the cleaning unit release lever to the front side until it locks.
13. Remove the drum protective sheet.
14. Close the main board bracket (1 screw) and the middle unit.
15. Perform the Vsg adjustment by SP#33. (See Vsg Adjustment.)
NOTE: Initial conditioning (SP#5) is not necessary. (It is necessary only
when the developer is replaced.)
16. Perform the light sensor adjustment. (See Light Sensor Adjustment.)
[F]
5-11
[D]
[B]
[C]
[G]
[H]
DRUM