Table of Contents
Advertisement
CORONA
[A]
[C]
[C]
11. Reinstall the wire cleaner [A].
NOTE: Make sure that the corona wire [B] is positioned between the
cleaner pads [C].
12. Reinstall the endblock-covers and grid wire terminal.
13. Install 4 new grid wires [D] and grid holders [E].
NOTE: 1) Make sure that the wires are correctly placed on the eight
slots [F] and in the eight holes [G].
2) Make sure that the wires are all straight and not crossed, as
shown.
3) Handle the new wires by the ends only. Oil and chemicals
from your hands will deteriorate the wires.
4) Do not bend the wires. This can result in an uneven charge.
14. Reinstall the charge corona unit.
NOTE: Make sure that the charge corona unit is set properly, and the
grid wires and charge corona wire are positioned facing the drum
surface.
15. Reinstall all the units and covers.
[B]
[D]
[F]
OK
NG
5-14
31 December 1992
[E]
[G]
Advertisement
Table of Contents
