Table of Contents
Advertisement
31 December 1992
3. Enter the desired output check number as follows:
a) Press the Margin key [C]. "00" will blink in the Leading Margin indicator
[D]. Enter the desired output check number using the Plus [E] or Minus
[F] key. (The output check numbers are given in the Output Check
Mode Table.)
b) Press the Margin Set key [G]. "00" will blink in the Trailing Margin
indicator [H]. Enter the desired output check number using the Plus or
Minus key. (The output check numbers are given in the Output Check
Mode Table.) Press the Margin Set key again.
4. Press the Copy Exit Way key [I] to turn the electrical components on and
off.
NOTE: When the selected component is ON, "1" is displayed in the Copy
Counter indicator [J]. When it is OFF, "0" is displayed in the Copy
Counter indicator.
5. Input a new output check number as follows: (When changing to another
number)
a) Press the Margin key. A number will blink in the Leading Margin
indicator. Enter the desired output check number using the Plus or
Minus key.
NOTE: It is possible to input a new output check number when the
number in the Leading Margin indicator is blinking.
b) Press the Margin Set key. A number will blink in the Trailing Margin
indicator. Enter the desired output check number using the Plus or
Minus key. Press the Margin Set key again.
NOTE: It is possible to input a new output check number when the
number in the Trailing Margin indicator is blinking.
6. To leave output check mode, turn off the DPS-101-7 and 101-8.
4-37
SERVICE TOOLS
Advertisement
Table of Contents
