Ricoh FW830 Service Manual page 116

SERVICE TOOLS
Mode No.
No. Leading Trailing
Margin Margin
Indicator Indicator
92 09 02
93 09 03
94 09 04
95 09 05
96 09 06
Function
Cut Error Correction 3 – Synchro Cut
297 mm
Correct cut error for synchro cut 297 mm.
Input the number according to the decal on
the roll feeder right cover
(0.1 mm/step).
This SP mode must be done when the
roll feeder is installed.
Cut Error Correction 1 –Synchro Cut
1189 mm
Correct cut error for synchro cut 1189 mm.
Input "0" or "1" according to the decal stuck
on the roll feeder right cover.
This SP mode must be done when the
roll feeder is installed.
Cut Error Correction 2 –Synchro Cut
1189 mm
Correct cut error for synchro cut 1189 mm.
Input the number according to the decal on
the roll feeder right cover
(10 mm/step).
This SP mode must be done when the
roll feeder is installed.
Cut Error Correction 3 –Synchro Cut
1189 mm
Correct cut error for synchro cut 1189 mm.
Input the number according to the decal on
the roll feeder right cover
(1 mm/step).
This SP mode must be done when the
roll feeder is installed.
Fusing Lower Limit Temperature
Select 3 modes in case the fusing
temperature drops below the lower limit
temperature.
4-30
31 December 1992
Data
0 ~ 9
+
0:
–
1:
0 ~ 2
0 ~ 9
0: Normal
1: Forced Copy
2: Auto Start