YASKAWA FSDrive-MV1000 Instructions Manual page 11

i.2 General Safety
NOTICE
Equipment Hazard
Observe proper electrostatic discharge procedures (ESD) when handling the drive.
Failure to comply may result in ESD damage to the drive circuitry.
Do not operate damaged equipment.
Failure to comply could result in further damage to the equipment.
Do not connect or operate any equipment with visible damage or missing parts.
Also check the cable wiring and selection of peripheral devices to identify the cause. Contact your Yaskawa
representative or the nearest Yaskawa sales office before restarting the drive or the peripheral devices if the cause
cannot be identified.
Install adequate branch circuit short circuit protection in accordance with the standards in the country of use.
Failure to comply could result in damage to the drive.
This drive is suitable for circuits carrying a maximum current when shorted of 5 kVA, with a maximum voltage of
2640 Vac (class: 2 kV) and 4576 Vac (class: 4 kV).
If disinfectants or insecticides must be used to treat packing materials such as wooden frames, pallets, or plywood, the
packing materials must be treated before the product is packaged, and methods other than fumigation must be used.
Example: Heat treatment, where materials are kiln-dried to a core temperature of 56°C for 30 minutes or more.
If the electronic products, which include stand-alone products and products installed in machines, are packed with
fumigated wooden materials, the electrical components may be greatly damaged by the gases or fumes resulting from
the fumigation process. In particular, disinfectants containing halogens, which includes chlorine, fluorine, bromine and
iodine can contribute to the erosion of the capacitors, and DOP gas (phthalate esters) can cause cracking of resins.
YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions 11