YASKAWA FSDrive-MV1000 Instructions Manual page 51

Figure 2.19
Shock-absorbing material
Square
timbers
Other Precautions
■
Devise measures to prevent the in-panel wiring and cables being damaged by rats or other possible causes.
Periodic Inspection
■
Inspect the following points every month.
• The color of the silica gel has changed, indicating that moisture was absorbed.
(Use the type of silica gel that changes color and check absorbency based on the degree of color change.)
• The drive is not wet due to humidity or roof leaks.
• The drive is neither corroded nor rusted (both the interior and exterior).
NOTICE: Before turning on the power to the drive after a long period in storage, carefully check for moisture and dust.
Failure to comply could result in damage by fire or other damage.
YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions
Sheet (Use two layers of sheeting at least 0.1 mm thick.)
Drive side face
50 to 100 mm
Figure 2.19 Preparing a Drive for Storage
Shock-absorbing material
Front of drive
Floor
2.4 Storing Drives
Square
timbers
2
51