YASKAWA FSDrive-MV1000 Instructions Manual page 161

6.1 Section Safety
NOTICE
Observe proper electrostatic discharge procedures (ESD) when handling the drive and circuit boards.
Incorrect handling could result in ESD damage to the drive circuitry.
Use only shielded cable to wire analog input/output signals for the control circuit.
Failure to comply could result in drive malfunction.
Use shielded twisted-pair wires and ground the shield to the ground terminal of the drive.
Do not allow unqualified personnel to perform work on the drive.
Failure to comply could result in death or serious injury.
The drive should be installed, wired, repaired, inspected, and have its parts replaced, by someone with a thorough
knowledge of drive installation, adjustment and repair.
Do not modify the drive circuitry.
Failure to comply could result in damage to the drive and will void warranty.
Yaskawa is not responsible for any modification of the drive made by the user.
Check all the wiring after installing the drive and connecting other devices to ensure that all connections are correct.
Failure to comply could result in damage to the drive.
Connect the wires with the correct phase order.
The motor will run in reverse if the phase orders are not matched.
Connect input terminals U, V and W of the motor to output terminals U, V and W of the drive, pairing the terminal
codes. The phase orders of the motor terminals and drive terminals should also match.
Do not operate damaged equipment.
Failure to comply could result in further damage to the equipment.
Do not connect or operate any equipment with visible damage or missing parts.
6
YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions 161