5.50 Network Statistics Registers; Statistics Register - Texas Instruments TMS320DM646x User Manual

Texas instruments ethernet media access controller (emac)/ management data input/output (mdio) module user's guide
Hide thumbs Also See for TMS320DM646x:
Table of Contents

Advertisement

Ethernet Media Access Controller (EMAC) Registers

5.50 Network Statistics Registers

The EMAC has a set of statistics that record events associated with frame traffic. The statistics values
are cleared to zero 38 clocks after the rising edge of reset. When the GMIIEN bit in the MACCONTROL
register is set, all statistics registers (see
subtracted from the register value with the result stored in the register. If a value greater than the
statistics value is written, then zero is written to the register (writing FFFF FFFFh clears a statistics
location). When the GMIIEN bit is cleared, all statistics registers are read/write (normal write direct, so
writing 0000 0000h clears a statistics location). All write accesses must be 32-bit accesses.
The statistics interrupt (STATPEND) is issued, if enabled, when any statistics value is greater than or
equal to 8000 0000h. The statistics interrupt is removed by writing to decrement any statistics value
greater than 8000 0000h. The statistics are mapped into internal memory space and are 32-bits wide.
All statistics rollover from FFFF FFFFh to 0000 0000h.
31
15
LEGEND: R/W = Read/Write; WD = Write to decrement; -n = value after reset
5.50.1
Good Receive Frames Register (RXGOODFRAMES)
The total number of good frames received on the EMAC. A good frame is defined as having all of the
following:
Any data or MAC control frame that matched a unicast, broadcast, or multicast address, or matched
due to promiscuous mode
Was of length 64 to RXMAXLEN bytes inclusive
Had no CRC error, alignment error, or code error
See
Section 2.5.5
statistic.
5.50.2
Broadcast Receive Frames Register (RXBCASTFRAMES)
The total number of good broadcast frames received on the EMAC. A good broadcast frame is defined
as having all of the following:
Any data or MAC control frame that was destined for address FF-FF-FF-FF-FF-FFh only
Was of length 64 to RXMAXLEN bytes inclusive
Had no CRC error, alignment error, or code error
See
Section 2.5.5
statistic.
5.50.3
Multicast Receive Frames Register (RXMCASTFRAMES)
The total number of good multicast frames received on the EMAC. A good multicast frame is defined as
having all of the following:
Any data or MAC control frame that was destined for any multicast address other than
FF-FF-FF-FF-FF-FFh
Was of length 64 to RXMAXLEN bytes inclusive
Had no CRC error, alignment error, or code error
See
Section 2.5.5
statistic.
124
Ethernet Media Access Controller (EMAC)/Management Data Input/Output (MDIO)
Figure
Figure 90. Statistics Register
for definitions of alignment, code, and CRC errors. Overruns have no effect on this
for definitions of alignment, code, and CRC errors. Overruns have no effect on this
for definitions of alignment, code, and CRC errors. Overruns have no effect on this
90) are write-to-decrement. The value written is
COUNT
R/WD-0
COUNT
R/WD-0
www.ti.com
16
0
SPRUEQ6 – December 2007
Submit Documentation Feedback

Advertisement

Table of Contents
loading

Table of Contents