a.
9600 baud
b.
8 data
c.
parity none
d.
1 stop bit
e.
full duplex
f.
XOFF
Note: If only one terminal is used for both Cores, the terminal will have
to be switched from side-to-side to access each module. An "A/B" switch
box can also be installed to switch the terminal from side to side.
4
Faceplate-enable all core and network cards.
Power up Core cards
Procedure 38
Powering up core cards
1
Disconnect NTRC17BA crossover ethernet cable from the faceplate of
CPU 0.
2
For AC-powered systems (NT8D29BA): set the MPDU circuit breaker
located at the left end of the module to ON (top position).
3
For DC-powered systems: faceplate-enable the NT6D41CA power supply
and then set the breaker for the Core 0 module in the back of the column
pedestal to ON (top position).
4
10 seconds after power up of Core/Net 0, press the INI button on Core/
Net 1.
Performing the upgrade
End of Procedure
61C to CS 1000M SG CP PIV Upgrade
Page 127 of 212