Fanout Panel Connections On The Cp Core/Net Backplane - Avaya 1000M Upgrade

Figure 23

Fanout Panel connections on the CP Core/Net backplane

Core backplane
Group 5 Group 4 Group 3
Group 7 Group 6
j3 j3
j3 j3 j3
slot 11 slot 11 slot 10
slot 12 slot 12
port 0 port 1
port 1 port 0 port 1
j4 j4 j4 j4 j4
slot 12 slot 12 slot 11 slot 11
slot 10
port 1 port 0 port 1 port 0 port 1
NT4N29 cable
j3 slot 9 port 0
Group 0
NT4N89 cable
A B
Group 2 Group 1
j3
j3
slot 10 slot 9
port 1
port 0
j4
j4
slot 10 slot 9
port 0
port 1
j4 slot 9 port 0
NT4N29 cable
c. parity none
d. 1 stop bit
e. full duplex
f. XOFF
4 Seat and faceplate-enable all 3PE, Per Sig, clock controller, core and
network cards.
Note: If only one terminal is used for both cores, the terminal must be
switched from side-to-side to access each module. An "A/B" switch box
can also be installed to switch the terminal from side to side.
Performing the upgrade
Network backplane
E D
End of Procedure
61C to CS 1000M SG CP PIV Upgrade
Page 83 of 212
System Monitor
(XSM) connections
J3
J2 J1
553-9473