Connect Lan 2; If The System Is Connected To A Lan - Avaya 1000M Upgrade

Procedure 36

If the system is connected to a LAN

1 Connect the Dual Ethernet Adapter (RJ-45) for I/O Panel (NTRE40AA) to
J31. Secure the adapter to J31 with the two screws included in the
shipment. Insert the adapter from the inside of the I/O panel.
2 Connect LAN 1 (Ethernet) on the CP PIV faceplate to J31 (top) of the I/O
panel with cable NT4N90BA. This connection can only be made after the
Dual Ethernet Adapter is installed (see step 1 above).
3 Connect J31 to a LAN switch.
Note: If a LAN switch is not available, connect J31 of Core 0 to J31 of
Core 1 by NTRC17BA cable.

Connect LAN 2

Connect the NTR17BA Ethernet crossover cable from LAN 2 on the CP PIV
card in Core 0 to the LAN 2 connection of the CP PIV card on Core 1.
This NTR17BA cable runs between the faceplates of the CP PIV cards and is
run through the front cable tray.
Performing the upgrade
End of Procedure
61C to CS 1000M SG CP PIV Upgrade
Page 125 of 212