Check For Peripheral Software Download To Core 1 - Avaya 1000M Upgrade

3 Configure the primary (active) and secondary (inactive) IP addresses:
LD 117
new host name 1 IP address
chg elnk active name 1
new host 'name 2' 'IP
address'
chg elnk inactive name 2
chg mask xxx.xxx.xxx.xxx
4 Enable the new Ethernet interface.
LD 117
update dbs
LD 137
dis elnk
enl elnk

Check for Peripheral Software Download to Core 1

Enter LD 22 and print Target peripheral software version. The Source
peripheral software version was printed in "Printing site data" on page 35. If
Performing the upgrade
Load the program
Define the first IP address:
"name 1" is an alias for the IP
address such as "primary". The
IP address is the IP number.
Assign the "name 1" address to
the active Core.
Define the second IP address:
"name 2" is an alias for the IP
address such as "secondary".
The IP address is the IP number.
Assign the "name 2" address to
the inactive Core.
Set the sub-net per local site.
This number allows external
sub-nets to connect to the
system.
Load program
Update the ELINK database
Load program
Disable the old IP interface values
Enable the new IP interface values
End of Procedure
61C to CS 1000M SG CP PIV Upgrade
Page 103 of 212