Table of Contents
Advertisement
Page 58 of 212
Performing the upgrade
Installing Core 1 hardware
Table 7
Core module ID switch settings (System Utility card)
Core 0
Core 1
NN43021-461
Standard 06.03
Procedure 8
Checking main Core card installation
The main Core cards are installed in the factory as shown in Figure 16 on
page
59:
1
NT4N65AC CP Core Network Interface (cCNI) cards:
Each system contains one NT4N65 cCNI card per Core/Net module. The
cCNI cards are located in slot c9. If not already installed, install a
P0605337 CP Card Slot Filler Panel to cover slots c10-c12, which do not
contain cCNIs.
Note: In the NT4N41 Core/Net
Network Interface (cCNI) Card in slot c9 must be configured as "group 0."
The cCNI and 3PE cards for group 0 communicate through the NT4N29
cable. Only one cCNI card is required for group 0 in a Meridian 1
Option 61C CP PIV.
2
Slots c13 and c14 are left empty. If not already installed, install a
P0605337 CP Card Slot Filler Panel in each slot.
3
NT4N48 System Utility (Sys Util) card is located in slot c15. Check side ID
switch settings for SU card in Core/Net 1 according to Table 7.
Position 1
On
Off
4
NT4N39 CP PIV is located in the Call Processor slot.
5
The N0026096 blank faceplate is located in the extreme right-hand slot
next to the CP PIV card.
June 2014
module,
port 0 on the NT4N65 Core to
Position 2
On
On
End of Procedure
Advertisement
Table of Contents
