Installing The Security Device - Avaya 1000M Upgrade

Table 13
Clock Controller switch settings for QPC471H, QPC771H
Systems upgraded to CP PIV must use the Meridian 1 Option 61C CP PIV switch
settings to enable Clock Hunt software. Use the settings in this table.
SW1
1 2 3
on on on
*Total cable length between the J3 faceplate connectors:
0–4.3 m (0–14 ft.)
4.6–6.1 m (15–20 ft.)
6.4–10.1 m (21–33 ft.)
10.4–15.2 m (34–50 ft.)
** Set to ON for Clock Controller 0. Set to OFF for Clock Controller 1.

Installing the Security Device

4 1
on off
Procedure 18
Installing the Security Device
The Security Device fits into the System Utility card (see Figure 22 on
page 81).
If the original system had an IODU/C, remove the Security Device from the
IODU/C for reuse.
1 Unlock the latches and remove the IODU/C card.
2 Remove the round 1/2" diameter IODU/C Security Device from the round
black Security Device holder on the top right corner of the IODU/C card.
3 Insert the Security Device into the Security Device holder on the System
Utility card with the "Avaya" side facing up. Check that the Security Device
is securely in place.
Performing the upgrade
SW2
2 3 4
off off off
End of Procedure
61C to CS 1000M SG CP PIV Upgrade
Page 79 of 212
SW4
1 2 3
** on *
off
off
on
on
4
*
off
on
off
on