Installing The Cp Card Cage In Core 1 - Avaya 1000M Upgrade

Page 72 of 212 Performing the upgrade
Table 10
Core module ID switch settings (System Utility card)
Core/Net 0
Core/Net 1
NN43021-461 Standard 06.03
Procedure 15

Installing the CP card cage in Core 1

1 Check that the card cage is configured as Core 1. See Table 10 for
instructions.
An NT4N41 Core/Net module with pedestal, top cap and
necessary cables should already have been installed. If
so, proceed to "Relocating Network cards to CP PIV
Core/Net 0" on page 76.
Position 1
On
Off
2 For AC-powered systems only, attach the new MPDU, part of the CP PIV
Upgrade kit, to the side on the NT4N40 card cage. The screws that secure
the MPDU are accessible from the power supply slot. See Figure 20 on
page 73.
Note: Prethread 2 bottom mounting screws at the back of the Core/Net
shelf.Check that the power harness at the right rear corner of the card
cage has been transferred from the old card cage to the CP card cage.
3 Slide the CP card cage halfway into the module.
4 Hold the card cage firmly and make the following connections at the rear
of the module.
a. In AC-powered systems, connect the remaining module power
connectors to J2 on the MPDU. Then plug the module power cable
June 2014
IMPORTANT!
Position 2
On
On