Introduction; Copyright, Limitation Of Liability And Revision Rights; Approvals; Symbols - Danfoss VLT Series Programming Manual

Introduction

1 Introduction
®
VLT HVAC Drive
FC 100 Series
This guide can be used with all
®
VLT HVAC Drive frequency
converters with software version
3.7x.
The actual software version
number can be read from
15-43 Software Version.
1.1.1 Copyright, Limitation of Liability and
Revision Rights
This publication contains information proprietary to
Danfoss. By accepting and using this manual the user
agrees that the information contained herein will be used
solely for operating equipment from Danfoss or equipment
from other vendors provided that such equipment is
intended for communication with Danfoss equipment over
a serial communication link. This publication is protected
under the Copyright laws of Denmark and most other
countries.
Danfoss does not warrant that a software program
produced according to the guidelines provided in this
manual will function properly in every physical, hardware
or software environment.
Although Danfoss has tested and reviewed the documen-
tation within this manual, Danfoss makes no warranty or
representation, neither expressed nor implied, with respect
to this documentation, including its quality, performance,
or fitness for a particular purpose.
In no event shall Danfoss be liable for direct, indirect,
special, incidental, or consequential damages arising out of
the use, or the inability to use information contained in
this manual, even if advised of the possibility of such
damages. In particular, Danfoss is not responsible for any
costs, including but not limited to those incurred as a
result of lost profits or revenue, loss or damage of
®
VLT HVAC Drive Programming Guide
equipment, loss of computer programs, loss of data, the
costs to substitute these, or any claims by third parties.
Danfoss reserves the right to revise this publication at any
time and to make changes to its contents without prior
notice or any obligation to notify former or present users
of such revisions or changes.

1.1.2 Approvals

1.1.3 Symbols

Symbols used in this guide.
NOTE
Indicates something to be noted by the reader.
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury or
equipment damage.
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
*
®
MG.11.CC.02 - VLT is a registered Danfoss trademark
CAUTION
WARNING
Indicates default setting
1 1
3