Danfoss VLT Series Programming Manual page 22

How to Programme
2.1.8 Parameter Selection
In the Main Menu mode, the parameters are divided into
groups. You select a parameter group by means of the
navigation keys.
The following parameter groups are accessible:
Group no. Parameter group:
0 Operation/Display
1 Load/Motor
2 Brakes
3 References/Ramps
4 Limits/Warnings
5 Digital In/Out
6 Analog In/Out
8 Comm. and Options
9 Profibus
10 CAN Fieldbus
11 LonWorks
12 Ethernet IP / Modbus TCP / PROFINET
13 Smart Logic
14 Special Functions
15 Drive Information
16 Data Readouts
18 Data Readouts 2
20 Drive Closed Loop
21 Ext. Closed Loop
22 Application Functions
23 Time-based Functions
25 Cascade Controller
26 Analog I/O Option MCB 109
After selecting a parameter group, choose a parameter by
means of the navigation keys.
The middle section on the display shows the parameter
number and name as well as the selected parameter value.
740RPM
Basic Settings
0 -01 Language
[0] English
2.1.9 Changing Data
The procedure for changing data is the same whether you
select a parameter in the Quick menu or the Main menu
mode. Press [OK] to change the selected parameter.
The procedure for changing data depends on whether the
selected parameter represents a numerical data value or a
text value.
®
VLT HVAC Drive Programming Guide
2.1.10 Changing a Text Value
If the selected parameter is a text value, change the text
value with the [
The up key increases the value, and the down key
decreases the value. Place the cursor on the value you
want to save and press [OK].
2.1.11 Changing a Group of Numeric Data
If the chosen parameter represents a numeric data value,
change the chosen data value by means of the [
navigation keys as well as the [
the [
Use the [
The up key enlarges the data value, and the down key
reduces the data value. Place the cursor on the value you
want to save and press [OK].
10.64A 1 [1]
0-0 *
2.1.12 Value, Step-by-Step
Certain parameters can be changed step by step or
infinitely varying. This applies to 1-20 Motor Power [kW],
1-22 Motor Voltage and 1-23 Motor Frequency.
The parameters are changed both as a group of numeric
data values and as numeric data values infinitely varying.
®
MG.11.CC.02 - VLT is a registered Danfoss trademark
▲ ▼
] [ ] navigation keys.
740RPM
Basic Settings
0 -01 Language
[0] English
Values
▲
] [
◀ ▶
] [ ] navigation keys to move the cursor horizontally.
113 RPM
Load depen. setting
1 - 60 Low speed load
compensation
100%
▲ ▼
] [ ] navigation keys to change the data value.
729RPM
Load depen. setting
1 - 60 Low speed load
compensation
1 0% 6
10.64 A 1 [1]
0-0 *
◀ ▶
] [ ]
▼
] navigation keys. Use
1.78 A 1(1)
1- 6*
6.21A 1(1)
1- 6*
21
2 2