Tray 2 Empty - Xerox Phaser 3330 Service Manual

Tray 2 Empty

The paper has run out in Tray 2.
Applicable Error
• 07-210: Paper Empty at Tray 2
Initial Actions
• Load paper in Tray 2.
• If problem persists use the following procedure.
Troubleshooting Reference Table
Applicable Parts
• Tray 2 Paper Empty Sensor, (PL 12.4.5,
Parts List 12.4 Optional Tray Feeder Pick
Up Unit Assy).
• Main PWB: Phaser 3330 (PL 1.0.7,
List 1.0 Phaser 3330
3335 and 3345 (PL 6.1.7,
WorkCentre 3335/3345
Troubleshooting Procedure Table
Step Actions and Questions
1. Enter dC330 Component
07-210 to check the Tray 2 Paper Empty
Sensor and Paper Empty Actuator.
The display changes when the sensor is
actuated?
2. Check that the sensor and actuator are
correctly installed and undamaged.
The sensor and actuator are good?
3. Install a new Tray 2 Paper Empty Sensor (PL
12.4.5, Parts List 12.4 Optional Tray Feeder
Pick Up Unit Assy).
If necessary, install a new Tray 2 Empty
Actuator (CSP-SCF Actuator Feed),
(PL 12.4. 13, Parts List 12.4 Optional Tray
Feeder Pick Up Unit
Does the error persist?
Xerox Internal Use Only
Wiring and Plug/Jack Map Reference
• Phaser 3330 Main PWB Connector Designators
• Phaser 3330 Control Panel PWB
• Wiring Diagrams for P3330/WC3335/WC3345
Parts
• WorkCentre 3335/3345 Main PWB Connector Designators
Main), WorkCentre
• DADF PWB
Parts List 6.1
• SMPS PWB
Main).
Control, code
Assy).
Yes
Go to step 4.
Go to step 3.
Go to step 3.
Phaser 3330 and WorkCentre 3335/3345
Troubleshooting
No
Go to step 2.
Go to step 3.
Complete.
2-55
Service Manual