Xerox Phaser 3330 Service Manual page 108

Jam Inside Machine
Paper has jammed in the Registration area.
Applicable Error
• 08-100: Jam1
Initial Actions
• Clear the jammed paper.
• Check that the paper guides of the tray in use are set correctly.
• Check the media. Is the media in good condition and listed as supported media?
• Ensure the size, orientation and type of media in the tray matches the media displayed in the UI
menus.
• Turn the printer off and then on again.
• If problem persists use the following procedure.
Troubleshooting Reference Table
Applicable Parts
• Feed Sensor, (PL 3.1A.20,
Frame (2 of 2))
• Registration Sensor, (PL 3.1A.20,
List 3.1A Frame (2 of
• Main Drive Assembly, (PL 3.5.18,
List 3.5 Drive)
• Main Board: Phaser 3330 (PL 1.0.7,
List 1.0 Phaser 3330
WorkCentre 3335 and 3345 (PL 6.1.7,
Parts List 6.1 WorkCentre 3335/3345
Main)
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the paper path for debris or
obstructions.
Does the error persist?
2. Enter dC330 Component
08-100 to check if the Feed Sensor (08-100)
is connected and working. If necessary,
install a new sensor
and Feed Sensor) (PL 3.1A.20,
Frame (2 of 2).
Does the error persist?
Xerox Internal Use Only
Wiring and Plug/Jack Map Reference
Parts List 3.1A • Phaser 3330 Main PWB Connector Designators
• Phaser 3330 Control Panel PWB
Parts
• Wiring Diagrams for P3330/WC3335/WC3345
2))
• WorkCentre 3335/3345 Main PWB Connector Designators
Parts
• DADF PWB
• SMPS PWB
Parts
Main) or
Control, code
(Registration Sensor
Parts List 3.1A
Yes
Go to step 2.
Go to step 3.
Phaser 3330 and WorkCentre 3335/3345
Troubleshooting
No
Complete.
Complete.
2-49
Service Manual