Adf Board; Upper And Lower Crum Holders And Crum Terminal - Xerox Phaser 3330 Service Manual

Service Parts Disassembly

ADF Board

Parts List 7.1 WorkCentre 3335 SCANNER and ADF
1. Remove the Scanner
2. Remove the Upper Platen
3. Remove the A4 Middle Platen
4. Disconnect P/J1 on the ADF Board
5. Remove 2 screws (silver, flanged, tap, 10 mm) and remove the ADF Board
WorkCentre 3335

Upper and Lower CRUM Holders and CRUM Terminal

Parts List 3.1 Frame (1 of 2)
WARNING: Do not perform repair activities with the power on or electrical power supplied to the
machine. The machine could activate and cause serious personal injury when the power is on or
electrical power is supplied.
1. Do steps 1-4 in the Preparation section
2. Undock the printer from the optional Tray 2 Base.
3. Remove the Front Door
4-82 Phaser 3330 and WorkCentre 3335/3345
Service Manual
(page 4-103).
(page 4-105).
(page 4-107).
(Parts List 7.1A WorkCentre 3335
ADF, PL 7.1.8).
(page
(page 4-13).
4-3).
(page 4-8).
ADF, PL 7.1.8).
ADF PWB
(Parts List 7.1A
Xerox Internal Use Only