Xerox Phaser 3330 Service Manual page 116

Bypass Empty
The Bypass Tray is empty.
Applicable Error
• 07-500: Paper Empty at Bypass Tray
Initial Actions
• Load originals in the Bypass Tray.
• If problem persists use the following procedure.
Troubleshooting Reference Table
Applicable Parts
• Bypass Paper Empty Sensor, (PL 3.2.10,
Parts List 3.2 Bypass
• Main PWB: Phaser 3330 (PL 1.0.7,
List 1.0 Phaser 3330
3335 and 3345 (PL 6.1.7,
WorkCentre 3335/3345
Troubleshooting Procedure Table
Step Actions and Questions
1. Enter dC330 Component
07-510 to check the Bypass Paper Empty
Sensor and Empty MP Actuator.
The display changes when the sensor is
actuated?
2. Check that the sensor and actuator are
correctly installed and undamaged.
The sensor and actuator are good?
3. Install a new Tray 2 Paper Empty Sensor (PL
12.4.5, Parts List 12.4 Optional Tray Feeder
Pick Up Unit Assy).
If necessary, install a new Empty MP
Actuator ,(PL 3.2.8,
Tray).
Does the error persist?
Xerox Internal Use Only
Wiring and Plug/Jack Map Reference
• Phaser 3330 Main PWB Connector Designators
Tray)
• Phaser 3330 Control Panel PWB
Parts
• Wiring Diagrams for P3330/WC3335/WC3345
Main), WorkCentre
• WorkCentre 3335/3345 Main PWB Connector Designators
Parts List 6.1
• DADF PWB
Main).
• SMPS PWB
Control, code
Parts List 3.2 Bypass
Yes
Go to step 4.
Go to step 3.
Go to step 3.
Phaser 3330 and WorkCentre 3335/3345
Troubleshooting
No
Go to step 2.
Go to step 3.
Complete.
2-57
Service Manual