General Information
Fuser
The Fuser consists of a halogen lamp, heat roller, pressure roller, thermistor and thermostat. It sticks
the toner on a paper by heat and pressure to complete the printing job.
Heat Roller
•
Thermostat
When the heat lamp overheats, the Thermostat cuts off the AC power to the Halogen Lamp to
prevent over- heating.
–
Thermostat Type: Non- Contact type THERMOSTAT
–
Control Temperature: 190
•
Thermistor
The Thermistor is a temperature detecting sensor.
–
Temperature Resistance: 7k ohms 180
•
Heat roller
The heat roller transfers the heat from the lamp to apply heat on the paper.
The surface of the heat roller is coated with Teflon, so toner does not stick to the surface.
•
Pressure roller
A pressure roller mounted under a heat roller that is made of a silicon resin, and the surface also is
coated with Teflon. When a paper passes between a heat roller and a pressure roller, toner
adheres to the surface of a paper permanently.
•
Halogen Lamp
–
Voltage 120 V: 115 ± 5% Voltage 220 V: 230 ± 5%
–
Capacity: 850 Watt ± 42.5 - W
1-28
Phaser 3330 and WorkCentre 3335/3345
Service Manual
Pressure Roller2
± 5
°C
° C (374°F
Halogen Lamp
Pressure Roller
±
10° F)
°C (356° F)
Thermistor
Thermostat
s3320-261
Xerox Internal Use Only