Profinet; Installing Profinet Slave Board - Epson RC90 Manual

2.5 PROFINET

 Make sure that the power is turned OFF before installing/removing any boards or
connecting/disconnecting any cables.
connecting/disconnecting any cables with the power ON is extremely hazardous
WARNING
and may result in electric shock and/or malfunction of equipment.

2.5.1 Installing PROFINET Slave Board

Appearance
The Fieldbus slave board is configured as follows at shipment.
Board Appearance
CN3
JMP1
DSW1 DSW2
RC700 / RC90 Option Fieldbus I/O Rev.14
RJ45 Connector
Status Display LED
Configuration
CN3
All Open
Installing/removing any boards or
LNK/ACT LED : Link status /
MS LED : Module status display
CS LED : IO Controller connection
DSW2 DSW1
SW1
SW2
SW3
SW4
All ON Fixed as above
2. Installation
Communication packet
reception or transmission
status display
status display
JMP1
SW1
IRQ5 JP1
SW2
IRQ7 JP2
SW3
IRQ10 JP3
SW4
IRQ11 JP4
SW5
SW6 IRQ15 JP5
SW7
1 2
SW8
All Open
221