Connecting A Camera; Figure 2-2 Camera Connections To Dvr; Table 2-2 Rear Panel Connectors - Honeywell Rapid Eye LT Installation Manual

Installation
Connector label Description
AUDIO IN/OUT Sound card connectors.
NOT USED DISABLED; use AUDIO IN.
ALARM INPUTS Screw terminal connectors for input and ground connection. Interface with devices such as
alarms. TTL type: minimum high level of +2.4 volts; maximum low level of +0.4 volts.
CONTROL OUTPUTS Screw terminal connectors for output and ground connection. Control I/O must be
referenced to the ground of the Multi-Media LT DVR. Interface with devices such as: lights,
sirens, locks, and so on. TTL type. The outputs do not directly drive devices; they control
relays that do so.
SERIAL PORT 1–4 Ports 1–2: RS232. Ports 3–4: RS485.
POWER SWITCH Use the power switch to turn the unit on and off. See
page

Connecting a Camera

26
Table 2-2 Rear Panel Connectors
for more information.
27
Caution Power down the DVR before connecting hardware to it. See
Multi-Media LT DVR
Figure 2-2 Camera Connections to DVR
SPOT
MONITOR
1 2
VIDEO
INPUTS
Connect the camera sequentially; that is, connect the first camera to VIDEO IN 1, the
second camera to VIDEO IN 2, and so on.
The BNC connector's low signal loss, ease of twist-on installation, and small size, make it
a common connector for CCTV connections. Honeywell recommends using a solder- or
crimp-type connector.
Powering the Multi-Media LT DVR
on page 27.
8-channel Multi-Media LT unit
5
1 2 3 4 6 7 8
TELCO
SERIAL PORT 2
LAN
IN
OUT
115-230V~
SERIAL PORT 1 VGA
50/60 Hz
NOT
5-3A
USED
USB USB
Powering the
COMMON
CONTROL
SYS FAIL
OUTPUTS
SERIAL
SYS GOOD
1 G 2 G 3 G 4 G
PORT 3
FAULT
RELAY
28V, 3A
MAX
SERIAL
PORT 4
1 G 2 G 3 G 4 G 5 G 6 G 7 G 8 G
ALARM INPUTS
ON/OFF
POW ER
on