Displaying Site Properties; Site Properties Reference - Honeywell Rapid Eye Operator's Manual

Running View

Displaying Site Properties

Site Properties Reference

24
2. In the Find Name Containing field (see
each other in the site's name. The first site where this combination of characters
occurs is automatically selected.
• You can type any sequence of characters in a site name: they can be at the
beginning, middle or end of the name. For example: to locate Rosde lab 35,
you can enter either 35 or sde.
• You have the option of typing in more contiguous characters of the site's name to
narrow the search.
3. Once the site that you are looking for is highlighted, start a session, as needed.
1. Using View, select a site name on the Sites tab. To view the site properties, do one of
the following:
• Place the mouse pointer on a site. A message appears—like a tool tip—showing
information about a site.
• Right-click on the site name to view the shortcut menu and select Properties.
• With the site selected, click Properties on the Actions menu.
2. To close the Site Properties dialog, click OK.
The following information displays on the Site Properties dialog:
• The Site Name. The site tree in Rapid Eye View software displays this Site Name set
by the Multi SA in the site's definition, using the Admin application.
• Version of the Rapid Eye software running on the unit and the unit's serial number.
• Time zone. Set by the Multi SA, to provide correct timestamps for recorded video.
• User Management: local or central. Data for your Multi SA.
• Connection. If a connection cannot be established, this field can be used to check the
phone number for a dial-up connection, or the IP address/computer name for a
network connection.
LocalView Site Name
At the unit, LocalView operators may see a Site Name that differs from the Site Name shown
in View's Site Properties report. The Rapid Eye unit's serial number is used as the default
Site Name in LocalView.
Caution If your user account gives you access to a Maintenance session, do not
change the Site Name on the System tab. This Site Name is used for
connections on a network that is enabled for DHCP and matches the Site
Name shown by LocalView at the unit.
1-4), enter a few characters that follow
Figure