Removing Ac Power Supplies; Figure 81: Lifting The Power Cord Restraining Clip - Allied Telesis x530DP Series Installation Manual

Appendix C: Removing Modules

Removing AC Power Supplies

202
This section contains the procedure for removing the following power
supplies:
PWR150 / PWR150R

PWR250

PWR800

PWR1200

The illustrations show the removal of a power supply from slot PSU A. The
procedure is the same for removing a power supply in slot PSU B.
Note
Allied Telesis recommends saving a backup copy of the
configuration file in the switch before removing or replacing power
supplies. For instructions, refer to the Command Reference for x530
Series Switches Running AlliedWare Plus at
www.alliedtelesis.com.
To remove a power supply from the switch, perform the following
procedure:
1. Lift the power cord retaining clip on the power supply. Refer to
Figure 81. The PWR1200 power supply does not have a retaining clip.
Figure 81. Lifting the Power Cord Restraining Clip