Start And Design Of The User Interface; Initial Start Of The Operation - Siemens SENTRON PAC5200 Device Manual

7.2

Start and Design of the User Interface

7.2.1

Initial Start of the Operation

Before starting the user interface, the following preconditions must be satisfied:
✧
Assemble the SENTRON PAC5100/5200 as described in Assembly.
✧ Connect the lines for measurement, communication and supply voltage as described in Electrical
Connection and observe the safety provisions.
✧
Switch on the devices needed for the measurement.
✧ Switch on the supply voltage of the SENTRON PAC5100/5200.
✧
Check whether the LEDs at the SENTRON PAC5100/5200 indicate that the device is ready (see
Dimensions).
✧
Match the IP address and the subnet mask of the network interface card of your computer to the device
settings.
✧
Check on the computer screen whether the LAN connection is up. Activate the LAN connection if it is down
(see the Windows manual or the Windows online help for information).
✧
For checking purposes, carry out the ping test as follows (example for Windows XP):

Click Start on the Windows interface.

Select Execute....

Enter cmd in the dialog and click OK.

Enter: ping 192.168.0.55.

Press ENTER.

Check the following output in the window.
Figure 7-1
✧
Start Microsoft Internet Explorer.
✧
Enter the IP address in Microsoft Internet Explorer (for example default IP address: http://192.168.0.55)
of SENTRON PAC5100/5200 and press ENTER.
The user interface opens with the Information tab  Show device information (see Figure 7-4).
SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Ping Test
7 Operation at Use of a PC
7.2 Start and Design of the User Interface
97