Siemens SENTRON PAC5200 Device Manual page 143

7.3.5.4 Memory Management
Default Settings and Setting Ranges
Table 7-14
Parameter
Event recorder
Measurement recorder
Trend recorder
Fault recorder
1)
The memory sizes for event list, PQ records and fault records can be changed.
2)
The memory size for trend recording is calculated automatically and forms the difference to 100 % of the
total memory size. The maximum total memory size of 100 % cannot be exceeded due to
parameterization errors.
3)
If the rest storage capacity fall below 31 %, it will mark as red color on User Interface, then the activation
is not possible.
To change the memory management, proceed as follows:
NOTE
When the device has been recording data for a longer period already, a modification of the memory areas might
lead to the following message:
„Memory size should not be changed now. If you active changes, all PQ data will be lost. Please backup data
before activation or cancel changes."
This message is only output if the stored data and the data to be expected exceed the storage capacity of the
SD card.
SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Memory Management
1.0 %
35.0 %
(the recording time depends on
the aggregation interval)
61.0 %
(residual storage capacity)
3.0 %
(Numbers of records depends on
the fault record time.)
Default Setting
Splitting
7 Operation at Use of a PC
7.3 Configuration of the Device
Setting Range
1)
1 % to 33 %
1)
33 % to 65 %
2) 3)
31 % to 63 %
1)
3 % to 35 %
143