Setting Administrative Parameters - Siemens SENTRON PAC5200 Device Manual

7.3.6

Setting Administrative Parameters

In the Configure tab you can view and if necessary edit the administrative settings. You can select the
parameters in the Administrative menu in the navigation window. These parameters can be changed in the
input/output windows Time synchronization, Communication Ethernet and Device and language.
NOTE
Observe the procedure for the device configuration described in Device Configuration Procedure when setting
the administrative parameters.
7.3.6.1 Time Synchronization
Default Settings and Setting Ranges of the Time Synchronization
Table 7-17
Source time synchronization
Time zone offset to UTC
Daylight Saving Time switchover
DST offset to UTC
Start of DST
End of DST
Primary NTP server IP address
Secondary NTP server IP address
Error indication after
Error indication after
SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Time Synchronization Settings
Parameter
Additional Parameters if the Source is Ethernet NTP
Additional Parameter if the Source is Fieldbus
Default Setting
Internal
+00:00
yes
+01:00
March
Last week
Sunday
02:00 AM
October
Last week
Sunday
03:00 AM
192.168.0.254
192.168.0.253
10 min
10 min
7 Operation at Use of a PC
7.3 Configuration of the Device
Setting Range
Internal
Ethernet NTP
Fieldbus
-12 to +13 (hours)
(in increments of 0.5 h)
no
yes
0 to + 2 (hours)
(in increments of 0.5 h)
Acc. to list boxes
(see Operating Parameters)
Acc. to list boxes
(see Operating Parameters)
Any
Any
No polling of the NTP server if
0.0.0.0 was entered
2 min to 120 min
2 min to 120 min
149