Siemens SENTRON PAC5200 Device Manual page 209

Table 8-8
Mode
Value
Reset hysteresis
State
Recording on
Clear MIN/MAX val
Reset counters
in process
(prompt whether selected function is
executed)
Password Protection
If you have selected the option Use password = no on the HTML page (see Chapter 7.3.4.1), you can use the
softkeys to parameterize the device without entering a password.
If you have selected the option Use password = yes on the HTML page (see Chapter 7.3.4.1), you must first
enter the activation password (default setting 000000) before you can edit the device settings. A prompt is
displayed for this purpose.
After you have entered the correct password, you can edit the parameterization using the softkeys within the
next 15 minutes. After this time you have to re-enter the password at the device.
SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Advanced Settings (cont.)
Parameter Default Setting
lower than greater than
smaller than
0 -1 000 000 000 to +1 000 000 000 (unit)
1.0 % 0.0 % to 10.0 %
ON ON
OFF (O)
acc. to current configuration
Record
No Yes (checkmark)
(no checkmark) No (no checkmark)
Reset
No Yes (checkmark)
(no checkmark) No (no checkmark)
No Yes (checkmark)
(no checkmark) No (no checkmark)
- NO
OK
8 Operation at Use of the Display
8.4 Parameterization
Setting Range
209