Devices without Display for DIN Rail Mounting
To mount the device on a DIN rail, proceed as follows:
Guiding of the
snap-on clip
DIN rail
Figure 5-3
✧
Pull down the release device at the snap-on clip and hold it in this position.
✧
Slide the device with the guiding of the snap-on clip on to one side of the DIN rail.
✧
Move the device into the desired position on the DIN rail.
✧
Release the release device. The device is now firmly mounted on the DIN rail.
The snap-on clip is set to a certain height position by default. To change the height position, proceed as follows:
✧
Lever the release device out of its guiding (no special tool required).
✧
Move the release device into the desired position.
✧
Press the release device back into its guiding.
NOTE
The assembly instructions above must be carried out correctly to ensure sufficient protection against touching
live parts.
UL-Certification Conditions
Field Wires of Control Circuits shall be separated from other circuits with respect to the end-use requirements!
SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
Pulling direction
Assembly of the DIN Rail Device
Snap-on clip
Release device
5 Getting Started
5.2 Assembly
73